How rapid tooling solutions help in the manufacturing of injection molded parts

These days prototyping techniques have achieved new heights and every now and then new products come into the market. But what an ideal prototyping method does is to pull up the production rate and conversion time without compromising on the quality of the product at all. Rapid tooling solutionsare usually chosen to produce real injection molded parts within the shortest span of time possible for the prototyping agency. This will help you to reduce the time gap between the development of the part and send it to the manufacturing unit. These speed up the entire process and helps the company in a number of ways including facing competition from the market. So here are a few things that you need to know about the process before you start into prototyping along with an agency.

How early can the first samples were produced by rapid tooling solutions

If you are looking for the shortest time span usually approved by the prototyping agencies when it comes to rapid tooling solutions then the time is usually within 15 days after the product has been approved by the DFM. This is applicable to injection molded parts only and every single product has its own time frame depending on the complexity of the product. But hopefully, you will get the first samples by 15 days depending on which you would be deciding whether to go for further production or you require certain modifications in your product. The rapid tooling solution services will help you out in any case where you decide to bring about certain changes in the first samples considering customer needs.

- Advertisement -

Get an online quote for the rapid tooling solutions service

You might have a different product in hand or a different kind of item that needs to be manufactured or dealt with in a similar manner. Under such cases just get in touch with an online rapid tooling agency and ask them to provide a quotation o the service that they are going to provide you with. This will help them togive you an approximate idea about the time frame required and the expenses of the service for various time frames. Accordingly, you can choose a service providing agency and go ahead with the work.

Make sure that the product is manufactured in different phases

One of the most common mistakes that prototyping agencies and manufacturing units make is that to meet the time frame they tend to start bulk manufacturing in a single phase. But that should never be the case for any new product. If you are working on prototyping a new product in the market then irrespective of the type of the product it must be manufactured in batches and phases and you must check out products from every phase as a sample.

Thus, if you are going ahead with rapid tooling solutionsor any other prototyping methods then make sure you keep the above-mentioned aspects into consideration so that you do not face any issue regarding the product later on.

- Advertisement -

- Advertisement -

Comments are closed.